원스톱 금속 가공 솔루션

회전 표면 거칠기 계산기

ONMY TOOLINGS · Turning Calculator

회전 표면 거칠기 계산기

Estimate the ideal theoretical turning surface roughness Ra and peak-to-valley cusp height from feed per revolution and tool nose radius.

온라인 계산기

결과는 위의 입력값을 기반으로 합니다. 예시 값은 설명을 위한 것이며, 특정 공구에 대한 속도/이송량 권장 사항이 아닙니다.

공식 및 계산 방법

Ra ≈ 1000 f² / (32 r) µm; Rt ≈ 1000 f² / (8 r) µm; ideal target feed ≈ sqrt(32 r Ra / 1000).

Theoretical turned finish improves with a smaller feed per revolution or a larger tool nose radius. The commonly used ideal geometric model gives Ra approximately f²/(32r), with consistent length units. The exact circle-based maximum cusp height is r − sqrt(r²−f²/4). The inverse result is a theoretical feed value to compare with actual machine and tool constraints.

주요 가정 및 한계

Not a prediction of measured Ra or a substitute for surface inspection. Insert wiper geometry, chatter, built-up edge, machine rigidity, workpiece material and edge preparation affect measured finish. Use the inverse result only as a first-pass geometric estimate.

자주 묻는 질문

Will the actual Ra match this result?

Not necessarily. This calculator estimates the feed-mark geometry under ideal stable conditions.

Can I keep increasing corner radius to improve finish?

An excessively large nose radius may raise cutting forces or chatter; assess the whole setup.

적합한 절삭 공구가 필요하신가요?

이 계산 결과를 가공 대상 재료, 기계 설정 및 필요한 공구 치수에 맞춰 적용하십시오. ONMY 공구를 살펴보시거나, 견적을 요청하시려면 귀하의 적용 사례를 알려주십시오.

선삭 공구 살펴보기견적 요청하기

기술 참고 자료: Machining Doctor — Turning Calculators. ONMY에 대한 계산은 독립적으로 수행되었으며, 출처 링크가 있다고 해서 이를 지지한다는 의미는 아닙니다.

맨 위로 스크롤

지금 바로 매출 증대

CNC 공구 업계의 진정한 베테랑이 필요합니다. ONMY 툴링이 업계 1위가 될 수 있도록 도와드리겠습니다.