Calcolatore dell'altezza della scanalatura a punta sferica
Calculate theoretical scallop height from a ball nose end mill diameter and stepover or reverse-calculate stepover for a target cusp height.
Calcolatrice online
I risultati si basano sui dati inseriti sopra; i valori riportati a titolo di esempio hanno scopo puramente illustrativo e non costituiscono raccomandazioni specifiche relative alla velocità e all'avanzamento per lo strumento in questione.
Formule e metodo di calcolo
h = R − sqrt(R² − (s/2)²); stepover = 2 sqrt(2Rh − h²); R = D/2.
The scallop is the ideal cusp left between adjacent tool passes on a locally flat surface cut with a full-radius ball nose. Smaller stepover generally reduces scallop height but increases the number of passes. The inverse calculation returns the centerline stepover corresponding to the requested geometric cusp height.
Ipotesi e limitazioni importanti
Scallop height is not equivalent to measured Ra, and complex 3D slopes change the effective cutter geometry. Runout, deflection and path orientation affect actual results. The model assumes ideal spherical geometry and parallel stepover.
Domande frequenti
Is scallop height the same as Ra?
No. Scallop height is the ideal peak-to-valley cusp between passes, not arithmetic average roughness.
Does it work on all 3D surfaces?
Use it as a starting point. Surface slope and tool contact location change effective geometry.
Cerchi l'utensile da taglio giusto?
Adatta questo calcolo al materiale del tuo pezzo, alla configurazione della macchina e alle dimensioni richieste per gli utensili. Scopri gli utensili ONMY o inviaci la tua richiesta per ricevere un preventivo.
Scopri le frese in carburoRichiedi un preventivoRiferimenti tecnici: Machining Doctor — Ball Nose Surface Finish. I calcoli sono stati effettuati in modo indipendente per ONMY; i link alle fonti non implicano alcuna approvazione.